Reeve Headless Bass - Nearly There. . . . .

More progress has been made!

I tend to save old strings to mess around and do a basic set up.
I don't do it every time but this seemed like a good candidate.
These came from a Jazz bass and I think I may have cut them  
a little short!!

Never mind, they are only temporary, I'll correct that later on.

Having fixed the broken joint and fitted a new battery, it was time
to plug it in.
Very nice, indeed!!

On passive there is quite a big sound to it with some tones that are
more than acceptable - turn on the active - Wow!
As you have seen from the previous post, it has an "old fashioned" 
looking circuit but there is a lot going on in there.
The rear control knob operates a five position rotary switch, which
takes you from a deep, powerful thud, though to biting highs.
After playing around with it for a while, I think my favourite is
position two - big bottom end with some mid bite. Nice!
I must have taken the strings of the Jazz, as they were loosing their
edge but on this, they seem just fine!

The bridge is totally floating and to be honest a bit of a fiddle but
seems to follow the design of some other Reeve basses I have seen.
The action and intonation aren't set at the moment - I'll get around
to that soon, as I think I will leave these strings on for the time being.

The frets have come up really nicely and the wonderfully "hand made"
string anchor works a treat, with the setting being done with the little
tool screwed into the bottom. How thoughtful!

A few minor jobs to finish off and then time to plug it into something
big and powerful!

Back next time with a full report.

Cheers. :)